热轧65Mn带钢CCT曲线及其相变行为研究

    Research on CCT Curve and Phase Transformation Behavior of Hot Rolled 65Mn Strip Steel

    • 摘要: 基于CCT曲线及不同冷速与膨胀量的关系,模拟了65Mn热轧带钢冷却过程中的相变行为、冷却速率与膨胀量变化规律。结果表明:当冷却速度在0~10℃·s-1时,65Mn钢室温组织由铁素体和珠光体组成,随着冷速的提高,铁素体含量逐渐减少。随冷却速度提高,单纯由相变引起的膨胀量增大,但在实际冷却过程中,由于冷却产生的收缩导致膨胀量与冷却速度并非是线性关系:0.5~2.0℃·s-1小冷却速度范围内引起的膨胀量逐渐减少,冷却速度在2~5℃·s-1下的膨胀量逐渐增加,冷却速度提高到5~10℃·s-1时,膨胀量又逐渐降低。

       

      Abstract: Based on the CCT curves and the relationship between different cooling rates and expansion, the phase transformation behavior of 65Mn hot rolled strip during cooling and the variation law between cooling rate and expansion were simulated. The results show that the room temperature microstructure of 65Mn steel is composed of ferrite and pearlite when the cooling rate is 0 ℃·s-1-10 ℃·s-1, and the ferrite content gradually decreases with the increase of cooling rate. In addition, with the increase of cooling rate, the expansion caused by phase transformation gradually increases, but in the actual cooling process, the expansion affected by cooling-induced shrinkage is not linear with the cooling rate: the expansion caused by the small cooling rate range of 0.5 ℃·s-1-2.0 ℃·s-1 gradually decreases, the expansion at the cooling rate of 2 ℃·s-1-5 ℃·s-1 gradually increases, and the expansion gradually decreases when the cooling rate increases to 5 ℃·s-1-10 ℃·s-1.

       

    /

    返回文章
    返回