7A09铝合金半固态触变成形工艺研究
Research on Thixoforming of 7A09 Aluminum Alloy in Semi-solid State
赵孟舟1, 雍艺龙1, 郝 炜1, 边冬梅2
点击:3405次 下载:0次
作者单位:1. 中国船舶重工集团公司 第十二研究所成形仿真研究室, 陕西 兴平 713102; 2. 乌鲁木齐石油设备安装公司, 新疆 乌鲁木齐 830019)
中文关键字:触变成形; 半固态; 铝合金; 力学性能
英文关键字:thixoforming; semi-solid state; aluminum alloy; mechanical properties
中文摘要:研究了7A09铝合金半固态触变成形时模具温度对制件充填能力的影响,以及压力、模具温度对制件力学性能的影响。在480 ℃ × 12 h固溶处理 + 120 ℃× 22 h时效的热处理制度下,模具温度在0~400 ℃时,温度越高,充填性能越好,制件力学性能越低;成形压力在0~375 MPa时,压力越大,制件力学性能越高。
英文摘要:The influence of die temperature on filling ability, the influence of press and die temperature on mechanical properties were studied in thixoforming of parts of 7A09 aluminum alloy in semi-solid state. After 480 ℃ × 12 h solution treatment + 120 ℃× 22 h aging treatment, when the die temperature is 0~400 ℃, the higher the die temperature is, the better the filling ability is, the lower the mechanical properties are; when the press is 0~375 MPa, the higher the press is, the better the mechanical properties are.