挤压温度对温挤压模具早期失效的影响的模拟分析与探讨
Simulation Analysis and Discussion of lnfluence of Extrusion Temperature on Early Failure of Warm Extrusion Die
庞祖高1 , 唐志强1 , 栗育琴2, 张银意1
点击:3058次 下载:0次
作者单位:1.广西大学 材料科学与工程学院 广西 南宁 530004; 2. 泸州职业技术学院 机械工程系 四川 泸州 646005
中文关键字:温挤压; 挤压温度; 早期失效; 数值模拟
英文关键字:warm extrusion; extrusion temperature; early failure; numerical simulation
中文摘要:针对某壳体零件温挤压模具出现严重的热磨损、热疲劳和压塌等早期失效现象,利用DEFORM有限元模拟软件进行模拟。结果表明,不同挤压温度下模具温度场的分布是不均匀的,模具载荷、等效应力以及模具硬度随着挤压温度的提高而减小,而磨损系数随着挤压温度的提高而增大,因此挤压温度应控制在700~800 ℃之间。
英文摘要:Aiming at die early failure, such as severe thermal wear, thermal fatigue and collapse etc, the warm extrusion process of a shell part was simulated using Deform finite element software. The results show that the die temperature field distribution is nonuniform under different extrusion temperature, the load of die, effective stress and hardness of die sharply decreases with temperature increasing, respectively, while wear coefficient increases with extrusion temperature increasing, so the extrusion temperature should be controlled at 700~800 ℃.